Luminescent Concentrators Based on Organic
Dyes for Improving Solar Cell Efficiency
الباحثونAdnan F. Hassan، Hussain .J. Mohammed and Suhad. H. Mohsen
المجلةInternational Journal of Scientific & Engineering Research Volume 8, Issue 6, June-2017
مختصر البحثAbstract— Erythrosine dye is fluorine organic and sensitive to light, so it is used to fabricate (LSC) thick layer from epoxy risen additive by the Erythrosine dye. The efficiency of silicon solar cell was measured before and after using the (LSC), the increment of efficiency occurred from (9.03) to (11.19). Also, the (absorption & fluorescence) stokes shift, radiated lifetime, fluorescence lifetime, and quantum efficiency was calculated.
Mixing two Organic Dyes to Fabricate Solar Cell Concentrator
الباحثونSuhad . H. . Mohsen، Hussain Jasem Mohammed and Adnan.F.Hassan
المجلةResearch Journal of Pharmacy and Technology
مختصر البحثABSTRACT: A luminescent solar concentrator (LSC) was made by mixing two organic dyes; erythrosine and, eosin y then silicon solar cell efficiency was measured before and after synthesizing the luminescent concentrators having the two mixing dyes. Significant improvement was noticed in the solar cell efficiency from (9.03) to (11.24). The best concentration of the mixing dyes was identified with equal proportions. Also, (Voc, Ish, FF, η) was calculated.
Mixing two Organic Dyes to Fabricate Solar Cell Concentrator
الباحثونSuhad . H. . Mohsen، Hussain Jasem Mohammed and Adnan.F.Hassan
المجلة Research Journal of Pharmacy and TechResearch J. Pharm. and Tech. 10(9): September 2017
nology
مختصر البحثABSTRACT: A luminescent solar concentrator (LSC) was made by mixing two organic dyes; erythrosine and, eosin y then silicon solar cell efficiency was measured before and after synthesizing the luminescent concentrators having the two mixing dyes. Significant improvement was noticed in the solar cell efficiency from (9.03) to (11.24). The best concentration of the mixing dyes was identified with equal proportions. Also, (Voc, Ish, FF, η) was calculated.
Diazotization Coupling Reaction for Micro Spectrophotometric Determination of Sulfamerazine in Pharmaceutical Preparations
الباحثون*Hussain.J. Mohammed، Hana Khazal, **Zahraa. L .Razzaq, ***Durgham. H.Khadum, Safaa. .H. Mohammed, Iqbal
المجلةInt. J. Pharm. Sci. Rev. Res
مختصر البحثNew, simple and sensitive specteophotometric method has been developed for the determination of sulfamerazine. The method is based on the diazitization coupling reaction of sulfamerazine with resorcinol in alkaline medium were studied. The reaction gave an intense water soluble yellow product that has a maximum absorption at 422 nm and Ԑmax of 2.97 × 104 L.mole-1.cm-1. A linear correlation (1-8µg per 25ml 0.4 – 3.2 ppm) was found between absorbance at λmax and concentration. The results obtained are both precise (RSD was better than 0.8) and accurate (relative error was better than – 0.11). The coloured product was found to be 1:1 sulfamerazine: resorcinol. The stability constant and the rate constant of reaction under optimized conditions at room temperature were 0.25 x105 L.mole-1 and 2.25x10-2 min-1 . The proposed method was successfully applied to the determination of sulfamerazine in synthetic samples of pharmaceutical formulation
New Cyclic Voltammetry of 3-(4-N-Pyridine-2-yl Benzene Sulfonamide Azo)-1-Nitroso Naphthol and the Use of it for Enhancement of Cobalt Oxide Nano Particles
الباحثونHussein Jasem Mohammed
، NONE
المجلةNano Biomed. Eng
مختصر البحثThe electrochemical behavior of the 3-(4-N-pyridine-2-yl benzene sulfonamide azo)-1-nitroso naphthol reagent and its complex with Co (II) has been studied at glassy carbon disk electrode in different supporting electrolyte at concentration 1 mol and scan rate (100 mV/s). 3-(4-N-pyridine-2yl benzene sulfonamide azo)-1-nitroso naphthol was used for enhance the properties of nano cobalt oxide by ligand exchange reaction on nanoparticles
Novel cyclic voltammetry behavior of 3-((benzothiazol-2diazenylnaphthalene-2,7-diol and use it for spectrophotometric determination of copper (II )in honey sample
الباحثونFatma .A. Khazaal ، Hussein. J.Mohammed b and .Muhammed .M.Radhi
المجلةJ o u r n a l o f A d v a n c e s i n C h e m i s t r y
مختصر البحثThe azo reagent 3-((benzothiazol-2-diazenylnaphthalene-2,7-diol] was synthesized and characterized by FT-IR ,1H-NMR and 13CNMR spectral techniques. The electrochemical behavior of the azo reagent and its complex with Cu (II) has been studied at glassy carbon disk GCE electrode in different supporting electrolyte at concentration (1M) and scan rate (100mv.s-1). Spectrophotometric determination of copper (II ) is based on the formation of a 2:1 complex with above reagent. The complex has λmax at(588) nm and Ԑmax of( 1.436x104)L.mol-1.cm-1 . A linear correlation (0.1 – 3.0 μg. ml-1) was found between absorbance at λmax and concentration . The effect of diverse ions on the determination of copper (II) to investigate the selectivity of the method were also studied . The stability constant of the product was (1.1x108 ) . The proposed method was successfully applied to the analysis of honey sample . m