Response to the design conditions of a tube-bundle thermal energy storage unit with paraffin-copper foam composite as a storage medium
الباحث الأول:
Ahmed Alhusseny
الباحثين الآخرين:
Nabeel Al-Zurfi
,
Qahtan Al-Aabidy
,
Adel Nasser
,
Hayder Al-Madhhachi
المجلة:
International Journal of Heat and Mass Transfer
تاريخ النشر:
11 مايو، 2024
مختصر البحث:
Abstract
Owing to its potential to limit the issues of intermittency and instability in solar energy by means of phase-change materials (PCMs), latent heat thermal energy storage (LHS) has met increasing attention and been widely employed in therma…
Abstract
Owing to its potential to limit the issues of intermittency and instability in solar energy by means of phase-change materials (PCMs), latent heat thermal energy storage (LHS) has met increasing attention and been widely employed in thermal-based systems. Most PCMs, however, inherently exhibit poor heat conductance leading to modest rate of charging. To master this drawback, highly conductive metal foams are utilized to upgrade the bulk heat conductance of a PCM resulting in an enhanced rate of heat transport; hence, accelerating the melting process. This enhancement way is employed to promote the response of a tube-bundle thermal energy storage unit configured of staggered tubes filled with high-porosity copper foam embedded in paraffin wax as a storage medium. To charge the thermal energy storage (TES) unit proposed, a relatively hot stream of water is allowed to flow across the bundled tubes through the voids in-between. To check how feasible the proposed design is, the tubes enclosing the TES medium and the water flow in the shell surrounding have been simulated by ANSYS Fluent CFD code. A variety of design factors has been examined to explore their influence on the charging performance attained including structural properties of the metal foam employed along with the configuration of the tube-bundle considered. The foam structural characteristics inspected are the porosity
and pore density
, while various tube-bundle configurations have been tested in terms of the packing density
as well as the shape of PCM tubes used
. Results indicate that for a certain tube-bundle configuration, the best response is acquired when denser foam with lower porosity is used, while the best performance can only be achieved with higher porosity due to the better TES capacity offered. For certain foam structural properties of
, it has been observed that increasing the packing density can save up to 56 % of the time taken for charging completion with up to 200 % increase in storage capacity leading to up to 48 % improvement in the system overall performance. It has also been found that using paraffin embedded with copper foam as a TES medium accelerates the melting process considerably and saves more than half the time taken to charge the corresponding TES unit based on pure paraffin. It is also worth mentioning that the currently suggested LHS unit is not only of simple configuration, but practically efficient as well, with outstanding gross performance
. Through a proper manipulation of design conditions, it has been found that the charging response can be notably improved leading to substantial promotion in the overall performance realized.
